Ponytail Nightmares When a Clog is Holding You Back


Professionals agree that pipes and sink clogs can be fixed through DIY, without necessarily having to call a plumber, although professional help is imperative if the problem gets out of hand. In most cases, repeated attempts may be detrimental to your plumbing system. However, with enough information and a little bit of knowledge about plumbing, you can successfully handle the clogging in your system. Drain cleaners are not recommended especially when fixing the problems yourself as these could introduce hazardous content in your home. When your systems are clogged, here’s what you should do.

Use a Plunger

The traditional plunger has a suction made of rubber on one end of the stick. However, there are new electric plungers available such as the vacuum cleaners. The function of the plunger is to create pressure on the clogged pipe or sink. As a result, using the plunger will enable you to suck out any large objects that could be the cause of obstruction. On the edge of the rubber suction, you can apply a layer of petroleum jelly, so the plunger doesn’t allow air to pass through. Pump the plunger over the drain to release the blocked water. Once your drain is unblocked, flash some hot soapy water to clean the pipes from inside.

Remove the Stopper

If you drain has a stopper for trapping solid items, then this DIY technique can be helpful. This method is perhaps the best and most efficient but is only applicable if your system is installed with a stopper. You can look to see if your stopper is designed for lifting or turning. Also, before working on your stopper, confirm if you will need to disassemble. Whichever the technique, make sure you are able to handle the problem systematically so as not to complicate it. You can use the manufacturer’s manual if you are unsure of how to go about the process. Once you have succeeded, you can clean the stopper and your drain from the inside using a wire brush before placing the back stopper. Once it is fitted as required, pour hot soapy water down the drain to wash the remaining particles off the surface of the drain.

Baking Soda and Vinegar

Using vinegar and baking soda is a natural solution as opposed to cleaning chemicals. When unclogging your drain using this technique, you can begin by pouring some baking soda down the drain followed by a cup of vinegar. Once that is done, give it a few hours and see if the particles causing the clog get dissolved. After that, pour some hot water down the drain to clean and eliminate any remnant particles. Although this is an ecologically-preferred technique, you may still end up using chemicals if it is not effective. In case your problems get out of hand, you can always seek assistance from the best plumber Toronto can offer.

To further prevent your plumbing systems from clogging again, carry out regular maintenance on the systems. Watch out for signs of accumulating dirt and replace the old and cracked pipes. Plumbing systems that are well-maintained will hardly cause any problems.

Related Posts Plugin for WordPress, Blogger...